图片展示
图片展示

Faismars Android Tablet PC How To Enable ADB USB Debug?

Author:Faismars Click: Time:2023-02-28 13:24:22

How to enter debug mode


This document will guide you how to put the ZC-328 series boards into debug mode for development use.

Wired debugging:

In this case, you need to prepare a dual male USB cable (see below) and install the driver in your computer.

1.     The driver will be attached, unzip it, right click to run with administrator rights to install it (the driver only needs to be installed one time!).

2.     Then unplug the jump caps between the USB ports and use the dual male USB cable to connect the OTG port of the board and the computer.

(1). Pull off the jump cap here, Jump cap is very small to be properly stored.

(2). USB cable connects to this USB port.


3.  If the devices are listed after entering “adb devices”, you are in debug mode.


Network debugging:

Network debugging does not require cables, jump caps or drivers to be installed, so it is more convenient to use, but there are requirements for system versions (Android 6.0 191022/Android 7.1 or above, some older versions also have network debugging enabled by default, you can verify it yourself).

In these system versions or above, we have enabled network debugging by default, the port is 5555, just use the adb tool to connect directly, but the premise is to ensure that the board and the computer can access each other (usually both are under the same LAN can be):

1.     Confirm that the board is connected to the network and obtain the board's IP address:

If WLAN connection, click [Settings] -> [About Tablet] -> [Status Information]

If wired connection, click [Settings] -> [More] -> [Ethernet]


2.   
Enter “adb connect [ip:port]” at the command line as follows:

If The "Connected" prompt means that it is connected.

3.     You can then type “adb devices” to check the list of devices attached and see the following message indicating a successful connection.

The IP address and network port of the connected device will be displayed.


 

ADB Tools Download:

If you do not have ADB tool, you can go to google android official download:

https://developer.android.google.cn/studio/releases/platform-tools?hl=en

Just download by corresponding system.


图片展示

Faismars is a company with many years of experience, with extensive knowledge in the field of industrial electronics and flight kits. 

Contact  Us

Address: 28/F, Building 371-1,   Wushan Road, Tianhe District, Guangzhou


Phone:+86 181 2426 6998

E-mail:mark150@foxmail.com


Hours:24/7 hour online

图片展示

Faismars  is a company with many years of experience, with extensive knowledge in the field of industrial electronics and flight kits. 

Contact  Us

Address:       28/F, Building 371-1,                                    Wushan Road,

                        Tianhe District, Guangzhou


Phone:          +86 181 2426 6998

E-mail:          mark150@foxmail.com


Hours:          24/7 hours online

Copyright © 2021.all right reserved by Faismars

Service Center

Please choose online customer service to communicate

Contacts
Phone
+86 181 2426 6998
Hours
24/7 hour
E-mail地址
mark150@foxmail.com
Scan a QR Code
Qrcode
Contact us
添加微信好友,详细了解产品
使用企业微信
“扫一扫”加入群聊
复制成功
添加微信好友,详细了解产品
我知道了